Our Services

Brake Inspection and Service

• Visually inspect hydraulic system for leaks and condition
• Remove all wheels and inspect brake linings, brake hardware and wheel cylinders
• Remove brake dust and deglaze brake shoes
• Adjust brakes
• Adjust parking brake
• Lubricate backing plate and adjust hardware

Brake Fluid Flush

• Check brake fluid for moisture and contamination
• Inspect all hydraulic lines and hoses
• Inspect calipers and wheel cylinders
• Inspect master cylinder and cap
• Clean dirt and old fluid out of master cylinder
• Flush old fluid out of master cylinder, calipers and wheel cylinders until clean
• Add new brake fluid to master cylinder as needed
• Road test vehicle for proper brake operation

Wheel Alignment Service

• Inspect suspension components for wear
• Adjust caster and camber if provided by manufacturer
• Adjust toe-in
• Center steering wheel while adjusting toe-in

Thrust Adjustment

• Same as above plus compensate for rear wheel tracking

Four Wheel Alignment

• Same as above plus set rear wheel camber and toe-in, as provided by manufacturer

Electrical System Service

• Inspect battery connections
• Charge battery to full capacity
• Load test battery and record readings
• Inspect alternator belt and adjust as required
• Perform alternator output test and record readings
• Perform starter draw test and record readings
• Perform test for draw on electrical system and record readings
• Replace battery if required

Fuel Injection Service

• Clean fuel injectors
• Clean ISC/ASC motor, as required
• Clean throttle body intake
• Visually inspect fuel lines and fuel rail
• Pressure test fuel pump
• Test and visually inspect fuel pump, pressure regulator, vacuum line and connections
• Decarbonize intake manifold
• Decarbonize intake and exhaust valves
• Decarbonize combustion chamber and pistons
• Test exhaust emission

Transmission Fluid Exchange

• Road test for engine performance, transmission operation and shift patterns
• Flush transmission cooler and cooler lines
• Flush transmission valve body
• Flush transmission torque converter
• Thoroughly clean all internal parts
• Flush out all contaminated transmission fluid and replace with clean fluid
• Install transmission additive to revitalize transmission seals and O-rings
• Road test vehicle for proper transmission operation
• Top off transmission fluid

Computerized Engine Analysis

• Check primary ignition signal
    - ignition module signal & computer signals
• Check secondary ignition output
    - plug wires, distributor & cap, rotor, spark plugs
• Perform power balance test
• Check alternator output levels
• Check starter draw
• Adjust ignition timing
• Adjust curb idle speed
• Analyze exhaust emissions
• Written results, recommendations, and repair costs

Air Conditioning Service

• Test system for proper amount of Freon
• Test Freon for moisture contamination
• Test Freon for air contamination
• Clean condenser fin
• Inspect and adjust A/C compressor drive belt
• Performance test A/C operation
• Inspect all visible A/C components for leaks and add Freon dye
• Test antifreeze for proper mix

Transmission Service

• Road test for engine performance, transmission operation and shift patterns
• Inspect condition of transmission fluid
• Inspect transmission mounts and linkage
• Inspect transmission and transmission cooler for leaks
• Remove transmission pan, replace filter and pan gasket, clean transmission pan
• Adjust bands and throttle linkage, as required
• Flush transmission cooler, as required
• Top off transmission fluid
• Test antifreeze for proper mix